Modelling and simulation (5cr)

Evaluation scale

H-5

Content scheduling

Course content:
- Numerical simulation using Ansys Fluent
- Fluid flow analysis
- Thermal analysis
- Laminar flow simulation
- Turbulent flow simulation
- Numerical schemes

Objective

After completing the course, the student:
- understands the chances and limitations of modelling in design process
- can make simple flow, heat transfer, engine and power plant models .

Content

Computer aided engineering, modelling and simulation to be made with applied software.

Materials

Will be provided by the teacher during the course.

Teaching methods

- Short lectures
- Learning by doing
- Project-based learning
- Tutorial and hands-on
- Assignments
- Final project

Exam schedules

- No exam, but
1) Laboratory assignments (60%), in total 6 different assignments to be submitted during the course
2) Final project (40%) to be submitted in the last week.

Pedagogic approaches and sustainable development

short lectures and supervised learning

Student workload

135 h of work load in total as explained in below
-------------------------------------------------------------
45 h: classroom learning
60 h : assignments during the course
30 h : final project

Evaluation methods and criteria

- The grade is determined according to the obtained points from the below items:
1) Laboratory assignments (60%) to be submitted during the course. Total 6 assignments.
2) Individual project to be submitted in the last week (40%).
- No exam.

Failed (0)

Less than 40% of the total points

Assessment criteria, satisfactory (1-2)

Grade 1: between 40-54% of the points
Grade 2: between 55-69% of the points

Assessment criteria, good (3-4)

Grade 3: between 70-79% of the points
Grade 4: between 80-89% of the points

Assessment criteria, excellent (5)

Grade 5: Above 90% of the points.